A lifted 2008 Ford E-350 4WD 6.0 van left our shop today with a new custom exhaust. The customer requested we install a 4" stainless steel Magnaflow exhaust. A Magnaflow muffler kit for an F-250 was modified to fit the E-350. This is a 24" muffler, the length was chosen to mellow the exhaust noise.
We installed V-band clamps on either side of the test pipe and modified the down pipe.
We installed V-band clamps on either side of the test pipe and modified the down pipe.
Magnaflow Muffler
| 
From the muffler to the rear of the vehicle
| 
Looking towards the engine
|
The routing of the exhaust tip
| 
A shot of the modified down pipe
| 
A close up of the clamp welded in to hold the heat shield in place
|
Custom exhaust hangers
| 
Close up on welds on pipe going into the muffler
| 
V-clamps on either side of the test pipe
|
Another job completed and a happy customer!
| 
| 
|
RSS Feed